Why does the automatic soldering machine go wrong?
The deviation of the automatic soldering machine is because the pulses sent by the controller will be caused by problems in the line, driver, motor, timing belt and assembly, so we also call it lost step in the field of soldering machines.
Automatic soldering machine deviation solution
1. If the starting speed and stroke of the motor of the rotating shaft are too fast, it will also cause lost steps. The rotating shaft designed by our company adopts a reduction ratio of 1:3, which can ensure that it is not easy to lose steps at the same speed.
2. Problems caused by the motor----The current field of soldering machines is dominated by desktop automatic soldering machines, but because the space problem of the desktop soldering machine limits the size of the equipment, most of the automatic soldering machines are installed It is an ordinary stepping motor, not a servo motor, so the high torque of the stepping motor will deviate when the automatic soldering machine is running at high speed. In response to this situation,
3. Problems caused by the synchronous belt ---- During the working process, the automatic soldering machine will work according to the motion trajectory we set, so in the process of frequent reciprocating and long-term operation, the synchronous belt will be worn to a certain extent. Lost steps occur.
4. Problems caused by the use of wires----According to our observation, many manufacturers in the industry pursue low prices when they choose to use wires. However, poor wiring connections are prone to occur when the automatic soldering machine works for a long time. And lead to the phenomenon of lost steps. Our company has always been pursuing high quality, so every machine and equipment produced adopts the national standard 0.5*4 trvv outer diameter, 5.58mm inner core, 1.68mm characteristics, minus 40-105℃ working range, and ultra-high flexibility trvv robot special line Cable, guarantee your normal use for more than 5-10 years.