The soldering system is mainly composed of an automatic soldering mechanism and temperature control, heating element, and soldering iron tip. At present, the mainstream automatic soldering machine in the domestic market has been successfully applied to the production industries of automotive electronics, digital, electronics, electroacoustics, LCD, and circuit boards. A breakthrough in the USB automatic welding program in the wire industry.
In addition to the motion function of the manipulator, the automatic soldering machine mainly needs to complete the soldering operation, so its core part is not only the welding system, but also the motion system. The motion system adopted by the machine includes imported motor, imported guide screw, and imported synchronous belt pulley. The temperature control adopts German Wilo, which has higher stability. Its core components:
During the use of the automatic soldering machine, do not put the tip of the soldering iron on the sponge to clean, just put the tin on the tip of the soldering iron in the tin box, so as to keep the temperature of the tip of the soldering iron from dropping rapidly, after using it up every day , Clean first, add enough tin, and then cut off the power immediately, which will help increase the service life of the machine.
Precautions during the soldering operation of the machine, the solder joints should not be too saturated and should be in the middle of three or four points. Otherwise, the solder joints are too large and they will easily disconnect with the solder joints next to them. The tin should be a small semicircle with the component feet. This way, the soldered circuit board is neat and the best, and the lead should not be too thin or long, the voltage drop during soldering should not be greater than 5% of the initial voltage, and gloves, protective glasses, etc. should be worn during operation.